All Heating mantles are individually constructed and factory inspected for the highest electrical standards. Each heating element is incorporated in woven fiberglass yarn and fitted into a spun aluminium housing, powder coated. All Heating mantles are supplied with built-in On-Off energy regulator.
Standard Heating Mantles are designed to take only one size of flask. Various sizes are available to fit round bottom flasks of capacity 100 ml to 20 Litres. The snug fit of the heating surface, which is in close contact with the flask, ensures good thermal efficiency.
Very Useful for heating Test Tubes,Crucibles, Small flasks, Beakers, etc.The heating element is Spiralled Nichrome wire enclosed in refractory casing.
Very safe compared to conventional bunsen burner.Can be carried anywhere and connected to the power source.No fire hazards since it gives no flame.Works on electricity, no gas required.Produces radiant heat.
Test Sieves offer the highest accuracy and reliability of sieve analysis. test sieves are designed and manufactured in all respects as per British Standard specification and available in ASTM also.
Sieve Construction : The frame is made of spun stainless steel without any joint in it. A clear rigid design of minimum weight and free from corners where the material could be lodged. Stainless steel SS 304 quality sieve cloth is used for highest performance. An essential feature of the test sieves is that the mesh should be flat and uniform and with permanent tension around the whole circumference. The same is fully observed in Test Sieves.
Micro Test Sieves : Micro test sieves are available in one piece brass frame of 3,4 and 6 inch diameter with suitable lid and receiver.
Coarse and Fine Test Sieves : Coarse and fine test sieves 8, 12 and 18 inches in diameter with Lid and receiver assembly are also available.
Wet Washing Sieves : For samples that need to be separated with the help of wet washing. Available in 8 inch diameter by 4 or 8 inch deep with brass frames. A complete range of aperture sizes are available.
There is no national or international specification for wet washing sieves. sieves will nest with sieves of similar diameter and can be fitted with mesh to any desired specification.
Lids and Receivers: Lids and receiving pans are available in stainless steel or brass in 8 and 12 inch diameter.
We are successfully catering to the international markets of South-East Asia, SAARC Countries, Parts of Europe and Africa.
We bring forth a range of Water Distiller with metal heater and silica heaters in model OPTI-M. Elegantly designed, these are available in different capacities to meet the requirements of research institutes, laboratories and industrial sectors. These water distillers produce highly treated and disinfected water. This distillation process helps in removing minerals and microbiological contaminants and can reduce levels of chemical contaminants. Made in compliance with international norms, our range of water distillers are known for their safe use and less maintenance.
"LAB-SIL" Water Distiller Model OPTI-M has a elegant design. The special features of distillation apparatus are as under :
This range of quartz single distillation provides answers to pure water requirements. High quality electronic grade quartz boiler ergonomicdesign together with minimum maintenance combine to provide a product that give reliable service for years The water distillate obtained fromquartz single distillation is better when compared with water distillate obtained from other type/method of Distillation, with utmost precaution thisapparatus can be used for acids. The unique condenser design ensures that the droplets of distilled water remain in contact with the cooling coilfor the longest possible time producing cold distilled water and pre-heating the boiler feed to increase efficiency.
Glass bead sterilizer is very convenient to use over Alcohol/flame for sterilizing implements like forceps, scissors, scalpels etc in the laboratory. It takes just 10 seconds to sterilize an instrument.
It ensures total sterilization by the destruction of all microorganisms in seconds.
It is ready to use in 45 minutes from cold start.
It is available in 3 sizes. All same except the crucible size is different. The instrument is supplied with 500 gms of glass beads.
We are the manufacturer, supplier and Exporter of Oven Incubator. These are manufactured by a team of deft experts employing latest machines and tools. To meet the diverse requirements of the customers, we offer all our Incubators in different sizes and specifications.
Double walled Construction inner chamber made of Mild Steel/ St. Steel & exterior made of G.I. sheets powder coated .The gap between the two walls filled with glasswool insulation.
A. V. Exports established in 2001 is recognized as one of the leading name in manufacturing and export of a wide range of high quality scientific and laboratory instruments. These equipment are fabricated using best grade material and advanced technology to meet the needs of research institutes, laboratories and other allied sectors. Further, we also make sure these are designed for safe usage, easily maintainable and absolutely damage free.
Backed by our vast experience and dedicated manpower, we have created a credibility for themselves in the market all due to their quality and unmatched performance. All our products are made in conformation with international standards and stringently tested on various parameters in order to provide flawless range to the clients. With our unmatched quality and customized solutions, we are successfully catering to the international markets of South-East Asia, SAARC Countries, Parts of Europe and Africa.